Publications





   Press release 30/01/2012

    2014

    • Neef, A.; Seyda, V.; Herzog, D.; Emmelmann, C.; Schönleber, M.; Kogel-Hollacher, M.: Low Coherence Interferometry in Selective Laser Melting. In: Physics Procedia, 56(2014), pp. 82-89

    • Dallinger, F.; Roux, E.; Havinga, J.; d'Ippolito, R.; van Tijum, R.; van Ravenswaaij, R.; Hora, P.; van den Boogaard, T.: Adaptive process control strategy for a two-step bending process. In: Sustainable Design and Manufacturing 2014, (2014), Cardiff, Wales, UK, pp. 230-390

    • Dallinger, F.: Strain path dependent evolution of yield locus based on HAH model description. In: Sfar, H.; Maillard, A. (Edt.): Proc. International Deep Drawing Research Group Conf. IDDRG 2014, (2014), published

    • Stellin, T.; van Tijum, R.; Merklein, M.; Engel, U.: Study of a microforging process of parallel ribs from metal strip. In: Larkiola, J. (Edt.): Material Forming - ESAFORM 2014, (2014), pp. 565 - 572

    • Koops, R.; Sonin, P.; van Veghel, M.: Calibration standards to enable traceable in-process measurements of critical to quality product parameters. In: Proceedings Macroscale 2014, (2014), published

    • Reh, T.; Li, W.; Burke, J.; Bergmann, R.B.: Improving the Generic Camera Calibration technique by an extended model of calibration display. In: J. Europ. Opt. Soc., 9(2014)14044, published

    2013

    • Renken, V.; von Freyberg, A.; Goch, G.: Potenziale in der Automatisierungstechnik durch Verbindung von speicherprogrammierbaren Steuerungen mit Methoden der künstlichen Intelligenz. In: Das Forum für Fachleute der Automatisierungstechnik aus Hochschulen und Wirtschaft: Tagungsband AALE 2013, 10. Fachkonferenz, , (2013), Stralsund: DIV, pp. 157-170

    • van Ravenswaaij, R.; van Tijum, R.; Hora, P.; van den Boogaard, T.; Engel, U.: Towards zero-defect manufacturing of smal metal parts. In: IDDRG 2013 Conference Proceedings, (2013), Zurich: Institute of Virtual Manufacturing, ETH Zurich, pp. 87-92

    • Stellin, T.; Merklein, M.; Engel, U.: Investigation on a Microextrusion Process of Parallel Protrusions from Metal Strip. In: M. Jun, S. Park (Edt.): 8th International Conference on MicroManufacturing (ICOMM 2013), (2013), pp. 169-174

    • Havinga, G.T.; van den Boogaard, T.; Klaseboer, G.: Sequential Optimization of Strip Bending Process Using Multiquadric Radial Basis Function Surrogate Models. In: Key Engineering Materials, 554-557(2013), pp. 911-918

    MEGaFiT is co-funded by the European Commission under grant agreement n° 285030

    Copyright © 2017 www.megafit-project.eu. All Rights Reserved.

    For more information please contact info@megafit-project.eu